You will need a special tool to remove these one way screws if they are securely tightened. Im not even 100 I dont have one on hand but I believe the thumb turn tail piece is square instead of the Kwikset D and then you could time it to be horizontal for locked. Remove the deadbolt latch by sliding it out the side edge of the door. The only Kwikset I think you can change the orientation of is that weird geared deadbolt that nobody ever installs correctly. Deadbolts are often used in association with a keyed knob or lever for the additional security they. Because there is no spring mechanism added security is provided. The deadbolt can only be opened by manually turning the key or by rotating the turn piece. Its anti-pry shield can help you protect the door from the rear side, ensuring no one can jimmy the bolt open from the space between the door and frame. A four-way latch fits on the other side of the door for additional protection. Remove the two screws that hold the latch in place with the Phillips screwdriver. Kwikset Deadbolts A deadbolt is a locking mechanism that does not have a spring latch. The deadbolt includes a 1-inch long bolt that will fit doors between 1- to 1-¾ inches thick. Remove the two mounting screws from the interior cover using the Phillips screwdriver. Helpful Hint: These one-way screws are great for iron gates where someone could reach through the bars and unscrew the deadbolt from the inside and gain access to the property. How do I remove my Kwikset deadbolt Pry off the inside deadbolt cover using a small flat-blade screwdriver. Handlesets: 689 Dakota and Farmington Double Cylinder Handlesets Step 3 Feed the anchor fittings through the holes in the latch mechanism from the outside of the door. Step 2 Screw the latch mechanism into the door through the two holes in the latch plate on the side of the door. These are factory orginal replacement tie bolts.ĬOMPATABILITY: Deadbolts: 665 Double Cylinder Deadbolts Hold the wood in place with one hand and pound on the wood until the latch sits flush with the side of the door. These one way bolts provide additional protection against someone being able to gain access to your home and then removing the deadbolt from the inside of the door. Re-insert the latch, making sure the “UP” marking on the latch is facing up.The Kwikset 665 One-Way Double Cylinder Deadbolt Tie Bolts are designed to replace the standard phillips head tie bolts. If it’s not, remove the latch and rotate the mechanism 180 degrees (while holding onto the actual deadbolt) to change the position of the middle hole. Slide the latch into the door, making sure that the middle hole in the latch is centered within the hole in the door. #Remove kwikset deadbolt installTo begin install the new door latch if you’re not using an existing one. Mechanical deadbolts are simple to install, many requiring just a. Let’s get to the good part! Step Two: Install the SmartCode Smart Lock This double door lock system is usually found in commercial or industrial applications. You now have a clean slate to install your new smart lock. If you do need to remove the existing latch, just remove the two screws holding it in place and pull it straight out. However, if your existing deadbolt is from Kwikset, you can use the existing latch and keep it installed, as it’s identical to the one that the smart lock comes with. You may have to slightly tap on it with a mallet to loosen it up if it doesn’t come off easily. Just separate the outside and inside portions of the deadbolt to remove the whole thing from the door. After removing those screws, the entire deadbolt should come apart pretty easily.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |